The triple pressure switch is mounted on a dry bottle and consists of a high voltage switch, a low voltage switch and a medium voltage switch. The low voltage switch and the high voltage switch are connected in series and form a loop through terminal 1 and terminal 2. When the A/C switch is ON, the current direction of the switch is: A/CECU (air conditioning microcomputer) A23 foot → triple pressure Switch 1 foot → triple pressure switch 2 foot → PCM C13 foot, to the PCM to provide air conditioning to join the high signal.
When the medium voltage switch is turned on, it gives a high level signal to the PCM to enable the electronic fan to run at a high speed. Its current direction is: A/CECU's A23 pin → Triple pressure switch No. 4 pin → Triple pressure switch No. 3 pin → PCM The B22 pin, PCM after receiving this signal to its A17 foot iron, control the combination of high speed relay cooling fan and cooling fan high-speed relay, so that the condenser fan and cooling fan high-speed operation, the condenser cooling forced cooling (6).
The operating conditions of the triple pressure switch are shown in Fig. 4.
The light sensor is installed in the middle of the front windshield defrost opening in the center of the instrument panel to detect the light level, and sends this signal to the A/C ECU for setting the temperature correction so that the air temperature and the air volume blown by the air conditioner are always close to Set the temperature value. The light sensor is actually a photodiode, which can change its output voltage according to the change of illumination.
The outside temperature sensor, also called the ambient temperature sensor, is installed in front of the front bumper rear condenser to detect the outside ambient temperature. After receiving this signal, A/CECU is also used to set the temperature correction. The sensor is actually a thermistor with negative characteristics. Its output characteristics are shown in Figure 5.
The remote ship auto air conditioning self-diagnosis remote ship auto air conditioning with self-diagnosis function, when the system fails, you can from the air conditioning control panel temperature display to retrieve the fault, to provide help for maintenance. The self-diagnosis flow is shown as 12.
Bronze Components consists of a variety of alloys: Cu, Zn, Sn, Mn, Al, has a high corrosion resistance and wear resistance. Our CNC machining bronze has the following models: C220, C510, C630, C863, C936. Bronze Components in the sea water, salt water immersion has a very good tolerance. Bronze Components used in the ship, automobile, consumer and industrial sectors. Bronze Components have good electrical conductivity, easy to heat, to ensure safety at the same time with a strong anti-fatigue. Bronze Components has excellent mechanical machining performance and chip performance, can quickly shorten the parts machining time.
Machining Bronze Components, Precision Turned Bronze Parts, Phosphor Bronze Parts, CNC Machining Bronze Parts
Hong Kong RYH CO., LTD , https://www.szcncmachining.com