The most frequent repair item for a jaw crusher is to replace the thrust plate. To the link is integral crusher to remove the thrust plate, a baffle plate must be screwed bolt, lubricating cutting oil dry tube, the thrust plate is hung from the crane lifting hook or other lifting device, and then release The spring at one end of the horizontal link pulls the movable jaw to the fixed 颚 direction and takes out the thrust plate. If the back thrust plate is to be removed, the connecting rod should be pulled apart from the front thrust plate and the moving jaw, and the rear thrust plate should be taken out.
After the thrust plate is removed, cut off the thin lubricating oil pipe and the cooling water pipe, support the bracket under the connecting rod, and then remove the connecting rod cover to lift the connecting rod. The main shaft of the crusher should be removed together with the pulley and flywheel. Move the motor ( along with the belt ) along the slide rails as far as possible toward the crusher and remove the V-belt. Then lift the shaft with a crane. In order to disassemble the moving shovel, the dry oil lubricating oil pipe must be cut off, the pull rod removed, the bearing cap removed, and then the crane pulled out with a crane or other lifting equipment.Plasma Consumables For Lincoln
Changzhou Cewoo Equipment Co.,Ltd , https://www.cewoocut.com