For users who install ABS systems, how can they save time and effort, and install the ring gear without injury? Today, Hugo introduced to everyone a little trick to install the ring gear, which is more reliable than the method of directly heating the gas ring and causing the ring gear to deform and affect the monitoring accuracy.
Clean the hub of the gear ring to be installed
Many trailer factories or repair shops usually use gas welding to directly heat the ring gear while installing the ring gear. When it is red, it is then knocked into the wheel hub. This method of installing the ring gear can easily make the originally flat ring gear ring. Uneven force and deformation, resulting in the rotation of the wheel ring and the sensor gap is not uniform, there is no monitoring of the situation.
New gear ring to be installed
The new inner diameter of the ring gear is small and cannot be installed directly
Hugo’s method uses the principle of thermal expansion and contraction to put the new ring gear into the waste oil and evenly heat it. When the temperature reaches a certain temperature, the entire ring gear expands slightly due to heat. It can be easily placed directly into the hub slot, without disrupting the flatness of the ring.
In addition to violent typing, it is difficult to fit the new gear ring into the hub slot
Find a stainless steel basin or other container to put the new ring gear into the waste oil and heat evenly
Knowing the principle, the following work is very simple. Only need to find a stainless steel basin or iron barrel that can completely accommodate the ring gear, put it into the waste oil, and then evenly heat for a while.
The standby oil can be taken out after being smoked by heat
If the conditions permit, it is best to use gas stoves and other equipment to heat, if not conditions, you can directly use gas welding, but need to pay attention to adjust the gas welding temperature, avoid excessive temperature or fixed heating and burn the container.
Heating temperature should not be too high, otherwise it will ignite oil
Take the ring gear
The heated ring gear is very easy to put into the hub
After the standby oil smokes and boils, we can remove the ring gear from the pot. At this time, because of heat, the entire ring gear expands and the inner diameter increases, and it can be directly put into the wheel slot of the hub, which is very labor-saving. After putting it into the slot, turn it a half turn to make sure it is in place, then wait for it to cool naturally.
After the ring gear cools, clean it with chemical oil cleaner
After cooling, the ring gear will be tightly stuck in the hub slot. The last job is to use the detergent to clean the residual waste oil on the ring gear. After the ring gear is clean, the entire ring gear installation process is completed. .
â— Postscript:
There are many factors that affect the stable operation of the ABS system, and installing the ring gear is a problem that many people overlook. The installation of the completed ring gear using Hugo's technique allows a constant measurement gap between the ring gear and the sensor, ensuring monitoring accuracy and making the installation process easier and easier.
Film Grade Masterrbatch Slice,Pet Film Grade Slice,Film Grade Slice,Film Grade For Textile
Jiangyin jietong international trade company , https://www.jietongpetresin.com