Inside the structure of the manual gearbox there is a very important device that is the "synchronizer". The role of the synchronizer is very obvious, that is, when the gear is shifted, the speed of the gear on the power output side is faster than that of the gear that will soon be switched into this gear. If there is no synchronizer, a slowly rotating gear is forced into a high speed. In the rotating gear, teething will definitely occur.
More advanced tri-cone synchronizer
Synchronously speaking, it is said that the friction plate is arranged on the combination sleeve and the gear set. Unlike the general friction plate, the friction surface is conical. The role of this group of friction plates is to advance the friction between the straight teeth and the set teeth of the disk beforehand, so as to transfer the energy of the larger rotational speed to the lower rotational speed side, so that the rotational speed of the smaller rotational speed side increases the rotational speed. It is synchronized with the rotation speed of the larger speed. This can not only ensure normal shifting, but also play a buffering role, and the number and material of the cone friction plate group directly affects the performance of the synchronizer.
High Grade Acetic Gasket Maker
Feature:
This product is one kind of sulfur Silicone Sealant with one acid component which could be applied at any climate and could take chemical reaction with the water in air rapidly. Good aging-resistant ability, high flexible, perfect performance of high or low temperature resistant. Several machine waster water resistant, good elastic. Color: transparent, black, grey, blue, red.
Main Component:
α, ω-Dyhydroxyl Methyl Silicone
Scope of application:
This product is used for sealing of car, gear case of motor, fore-and-art board, water pump , plane flange, cover board of other machine equipment.
Using Method:
1.Cleaning up the surface with the cotton fabric, guarantees the surface not to have the dust, the greasy dirt, the rusty stain and so on.
2.In order to obtain good outward appearance, paste the temporary protection adhesive tape , near the place to be pasted after clean the surface, pull out after paste glue.
3. Pierce the seal with the cap, cover the mouth, cut bevel the tube mouth.
4. Spread the sealant evenly on the place which need to be sealed or bonded. The operation should be continuously, guarantee the sealant continuously squeeze out at cylinder shape, move the glue mouth evenly and slowly, prevent the form of bubble or hole is move too fast.
5.The sealant form shape at approximately 10 minutes, when assembly maintains the gasket thickness, fold gathers the curing at normal temperature 24 hours.
Warning:
1. This product will release a few acetic acid in the solidification process, the working conditions should maintain ventilate.
2. Do not put within kid`s reach, non-toxic after solidifies completely, avoid eye contact before solidification, if touches the eye carelessly, use massive water to wash, if serious go to see a doctor.
3. When operation, must hold the glue steadily, cannot separate, guards against mixes in the air and form bubble , affects the seal effect.
4,After operation, take off the cap mouth immediately, close the packing cover tightly to prevent the moisture enter and cause solidification. Wipe off the glue left at glue mouth.
5,This product should be operated at temperature 5-40℃,relative humidity 40-80%
Gasket Sealer,Acetic Gasket Maker,Instant Gasket Sealant,Sealing Adhesives Cream
Hunan Magpow Adhesive Group co.,ltd , https://www.magicglue.net